Previously CO have had problems with NAS if you store all the images over there (referenced catalogue, actual catalogue files are always in internal HDD, preferably a SSD). Also key files are getting copied to MS One Drive (about 1TB) They are built as Synology RAID and I have attached a 4TB USB drive to the NAS to back up the NAS daily, should it happen to anything in the NAS. I use a Synology 918+ NAS with 3x 3TB WD Red Drives with an 256GB SSD HDD. Once I have deduplicated the stored files, some of which seem to have been breeding over the years. So right now I am anticipating an interesting and informative learning curve with the new NAS. Small files, however, are not as speedy as one might expect until one reads more on the subject and starts to appreciate more fully why drives, spinning or solid state, are produced with rather different specs, capacities and costs. Not too bad though there are much much faster drives around if pockets are deep enough. One obvious discovery on the transfer via USB3 was that large files were written at about the claimed max speed for the drives installed. Good enough for general stuff but not exactly likely to set the speed traps off for intensive work. The NAS is connected to the router network via an ethernet socket in a Wi-Fi range extender as a temporary solution for connectivity. Whilst the Disk to NAS USB3 transfer was directly connected by system is not at this time. (As if nearly 4TB in total is not already a lot of files. I have yet to try that as a serious exercise - I should probably do the folder and file count comparison before throwing too many new files into the system. I can edit from the NAS, just as I can from the USB3 drives, but they do like to go into ECO mode as often as possible and that can be a little disruptive. I saw the unit as mainly a backup store rather than an interactive drive so in the end decided to go with lower spec drives and save a significant amount (8TB drives are quite expensive for an experiment!). However there are small discrepancies in the folder and file counts that I guess I need to check when I find a log file I can read. As I did't recognise those files at all, no the apparent file types, I was not too worried. The 3.5 TB on the 4TB drive took about 30 hours to copy over during which a read a lot about NAS drive performance.Īt the end the process advised that it had failed - however I think it might have been a reference to the 68 or so logged file failures. I had previously loaded a few smaller sources and one 240GB USB2 drive - which took a while. The NAS has a USB3 copy facility to I decided to copy over one of my 4TB drives (NAS has 2 8TB drives mirrored) and see what would happen. I'm WIndows rather than Mac and have just bought a recent model 2 disk NAS to rationalise my multi-external disk backup "system" after one of the more recent, larger and hardly used drives died without warning when seemingly doing nothing at all.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |